VECTOR 600 OFF ROAD
600 kg (1100 lbs)
The Vector 600 Off Road is designed to allow glaziers to unload, transport and install large plates of glass with extreme precision.
- Lifting capacity up to 600kg
- Robotic glazing machine
- Dual pump vacuum system
- Dual large rear and front wheels
- Ideal for on-site with uneven ground
- Precision adjustment for glazing
- Narrow foot print & highly maneuverable
- Pivots glass to side for transport through doors
- Manual 360 degree rotation and 90 degree
- side pivot left and right
- Variable Hydraulic Speed Dial
- Remote control for 4 degrees of movement:
Lift, Extension, Tilt and Sideshift
Can also handle:
- Composite panels
- Steel
- Granite/Marble
- Plastics
- Wood doors
- Vacuum cups and modified frame to lift curved glass
- Foam Vacuum Pads for Stone
- Electric lifting winch with hook
- Front lifting hook
- Purpose built trailer
|
|
Front lifting hook |
|
SPECIFICATIONS
Capacity: 500kg | |
Variable speed control hydraulic system | |
Overload sensor alarm | |
Hydraulic System: 24v / 1300watts | |
4 x 400mm Front & Rear Wheel | |
Battery: 2 x 12v / 120A Deep Cycle | |
Charger: 110 – 220v | |
Dual Vacuum Pumps: 2 x 24V | |
Vacuum Cups: 6 x 300mm sprung | |
Vac Cup Area Height: 1200mm | |
Vac Cup Area Width: 1850mm | |
Front Wheel Drive | |
No-Load Climbing: 15% Gradient | |
Machine Weight: 679kg, Counterweights: 336kg | |
SIDE SHIFT – 170 mm (7″) | |
Manual rotation: 360° |
TESTIMONIALS
Leer más
Just a quick note to say what a great piece of equipment. As I am a glazier that has a buggered back and now confined to the shiny seat in the office I reckon if the Nomad was around 25 years ago I would still be glazing commercial. We have just done our first two reglazes both 12.38 laminate 2400 x 3400 aprox 1000 off the ground in a local shop front. Last time it took 3hrs and 6 men to reglaze 1 panel only including scaffold and back pain. This time 4 people and the Nomad, no scaffold and 2 panels took 1 hour including loading the old 12.38 lam on the truck!!!!!! Possibly could have used 3 people but being the first time, are to be sure to be sure! Instant success and the knockers are now believers!! We set a frame approx 2 mtrs square up in the factory and used a piece of 8.38 lam for practice and used 6 people to glaze the panel two times each as a training session before tackling possibly the biggest reglazes in town. Thanks for the prompt service and I will recommend this machine and your business anywhere anytime. Regards extremely happy” Kym Wilson
